| Subject | Text |
| There probably is a bad connection between the LCD and driverboard.
Open the clock en gentley pus |
| Hello Shai,
It seems like, during transport, a dry solder joint or bad connection has been create |
|
|
| on the way to getting fixed | Hi Mark / Larry --
I haven't got it fixed just yet (as of 2/17). Probably within a week -- wait |
| Is the main fuse blown?
If yes, there's a problem in the primairy side of the power supply.
If |
| Maybe the vibrations of the subwoofer created a dry solder joint, or bad connector-connection!
Tr |
| Thanks for the warning mark.
I did put a load on each of the pins to make sure that it resonates |
| Can you post a photo of the spring and vcr-engine?
Mark |
| Sny 61" TV | Thanks Mark. I'll do that.
sorry for late reply.
Sean |
| Hi Jim,
I'm looking for the JVC MX-D401T service manual.
If you have it, and could share or |
| There probably are some dry solder joints or bad cable connections in this amplifier.
Just switch |
| Hi Mark thanks for ur clear & wide advice, I realy appriciate it.
1st Item, I had power ok. |
| Here's some example how to use the LM1086 with a regulated (in your case 3.3 V) output voltage:
[ |
| Transformers rarely break down it self.
Most of the time, it's the electronics supplying and cont |
| AVR 500 Service Manual | I found it here
http://manuals.harman.com/hk/Service%20Manual/avr500%20sm.pdf
Mark |
| PHILIPS MC 165 | HI, I'm looking for the servicemanual for the PHILIPS MC165.
Thanks,
Mark |
| Is the backlight working?
(If not, there could be a problem with the inverter-board.)
Do you hav |
| Do you still have high voltage on the tube? (static sound when turning on/off the screen)
And are |
|
|
| :?
hey Kendernauta
Winrar needs part 3!!!!!
please re-post - or do you know why it fail |
| re; repair | Hi, you need to call a tech, Mark is right about the shorted cap in the
HV circuit, you also need a |
| [quote:92340f53da="Al_Dodge_Bundy"]Looks very nice, I'll try to get there sometimes in the future.
|
| 1st item) Because you don't seem to have any high voltage, I'll would start by checking the HOT (lar |
| Hi Mark,
Thanks for your advice. I checked all the power resistors for the value and replaced the |
| Pfff, Guess the picture, that's harder then I expected :D
Isn't this the spring that pushes the |
| Hi,
Great camera! I've go one my self!
Had the same problem also!
Some contact below the ba |
| Indeed sounds like a failing belt or pinch roller.
You can buy service kits for most vcr's and mo |
| Start by checking the largest transitors near the flyback trafo (called HOT, used for H-deflection a |
| Mark you're on the right track. Try replacing your convergence ic’s. Don't forget to check the bias |
| Just use a switch with 2 seperate contacts.
e.g. a switch wich 2 * on-off-on connections.
e.g. |
| There are two causes for this failure:
1) Faulty tube, but most of the times two colors won't dis |
| Great tip, Chris.
Grtz Mark |